On a rowing machine, you don’t want to be wearing clothes that are too baggy as the fabric can get caught between the seat and the beam it slides on.  It’s not a disaster if that happens, but it can get annoying if your shorts keep getting caught there while you’re trying to get a serious workout.   It’s better to wear shorter, tighter-fitting shorts (nothing ridiculous), but just enough to ensure it doesn’t the material doesn’t hang down.
Most people who are new to the sport of rowing have difficulty achieving low strokes rates while trying to obtain their desired intensity – there are many comments such as “it does not feel hard enough?” or “how can I make it harder?” Rowing is about ratio and rhythm and you need to focus on a long stroke length and a powerful drive phase (push with the legs and pull with the arms). Give yourself time to learn this, it can take a few weeks before you start to feel the intensity at low stroke rates.
This piece of finely tuned, hand-crafted, water-resistance workout equipment also sits at the top end of the rowing machine spectrum. Employing a water flywheel that helps to mimic the feel of rowing in actual water, the natural wood WaterRower Rowing Machine will bring you a smooth, yet challenging workout that is as tough as you want it to be. If rowing is one of the best exercises you can do for your body as far as natural motion with low to no-impact, then the WaterRower is one of the best machines to do it on.

If you’re interested in using a rowing machine for focused training — whether for outdoor rowing, an indoor competition, or as part of a larger fitness program — you’ll want air resistance. If you’re drawn to rowers for the enjoyability (alongside the full-body, cardio-plus-strength training efficacy) of a rowing workout, consider a machine with water resistance.
After reading so many fantastic reviews I purchased the Classic model. Before I write what I think are the negative aspects I'll say that it gives a great workout! That is pretty obvious and I don't think that part is arguable. The disappointment began while unpacking. The wood parts were wrapped fairly well and did not have damage but there were several scratches that I had to sand out and re-oil. It appears that they were there before shipping. Putting it together would have been fast and easy- except 2 of the bolts were bent at about 15 degrees and would not fit. I had to wrap with tape and bend with vice grips. After getting it all together the rower worked well for about a week. I started to notice an annoying kind of popping sound from the left rail as the wheels rolled over on each stroke and recovery. It seems the plastic that the wheels ride on is not flat or adhered well to the rail. It isn't very loud but I can hear it well and it gets my attention, spoiling the nice sound of the water. Really disturbing. Support at WaterRower would like a video of the issue. Seems like an obvious issue and could swap out with a rail that is good instead of me trying to make a video of this small sound while moving the seat back and forth. For a $1500 machine the quality control- or lack of it is disturbing. Having to jump through a bunch of hoops because they are too cheap to just send a part is even more so. Perhaps I am being difficult but it is upsetting to have something touted as so great but put together like a $200 piece of junk. Another complaint would be the lack of any back lighting on the monitor. Really cannot see it if the lights are low. Being able to remove the monitor to attach to a PC wouldn't hurt either. While it gives a good workout the rower really suffers from poor manufacturing.
The Challenge AR features an advanced computer monitor providing the rower with measurable performance output, an ergonomically designed seat that rides on precision bearings and rollers for absolute smoothness, an upgraded footboard with advanced heel support, and an innovative soft grip handle to eliminate stress on the hands and wrist during the comfortable, but physical workout.
Other details include dual rails with four corner wheels that increase seat stability and reduce the amount of sweat buildup; a frame that flips upright for handy storage; and a weight capacity of up to 1,000 pounds. The WaterRower Classic measures 84 by 21 by 22 inches (W x H x D), weighs 117 pounds (with water), and carries a one-year warranty on the frame and components (WaterRower will upgrade the warranty to five years on the frame and three years on the components with the completion of a registration form).
There is some minor maintenance. Because it's made out of wood, which can expand and contract, the bolts need tightening every few months or so. It's easy and takes only a couple of minutes. That, and putting in a fresh water purification tablet every six to twelve months, are about it for regular maintenance. The only problem I've had with the rower (the reason for 4 stars instead of 5) was a squeak that developed after about 6 weeks. It took me some time to determine the source of the squeak, which was a metal bracket connecting the footrest board to the horizontal boards above the drum. I had to partially disassemble the top section and tighten four bolts, but that fixed the problem and it's been quiet ever since.
No matter the resistance we set or the power we applied, the machine remains sturdy, centered, and even. We amped up the intensity for 2000m sprints and found that the C2 supports consistent effort in a way water resistance can’t. The machine assists in keeping your intensity uniform, because it stores up remaining energy in the spinning flywheel. Comments about the ride feel of both Concept 2s were noticeably brief. As one tester put it, “It’s unremarkable because it’s good,” and leaves you free to focus on the effort you’re putting into your workout.

The WaterRower Club is hand crafted in solid Ash and stained for color. The WaterRower Club has been designed for High Traffic Areas such as Commercial Gyms, Studios, Rehabilitation Clinics, etc. Its Black Rails have been styled to prevent scuffing, other wooden components are finished in an attractive rosewood which are more resistant to soiling than the Natural model. Each machine has been hand finished with Danish Oil and Urethane for protection. Wood has been chosen due to its marvellous engineering properties, primary amongst these is its ability to absorb sound and vibration enhancing the WaterRower's quietness and smoothness of use. Ash, like all woods used in WaterRower construction, is a premium hardwood with incredible longevity and dimensional stability. s For reasons of ecology, all our woods are harvested from replenishable forests.
Most of the Waterrower range is made of wood harvested from the sustainably managed Appalachian forests of the eastern United States. The machines are extremely well built and are beautiful to look at coming in Ash, Oak or Cherry wood. If you are concerned about having an exercise machine in a living area, then one of the wooden models will fit right in to your living room. They are also extremely quiet in operation due to the wooden construction and the use of a strap rather that a chain. The only thing you can really hear is the swishing sound of the water in the tank as you pull giving you the feeling that you are really on the river!

The WaterRower Club is handcrafted in solid ash and stained for color. The wood was chosen due to its marvelous engineering properties, especially its ability to absorb sound and vibration, which enhances the WaterRower's quiet performance and smooth operation. Ash, like all woods used in the construction of the WaterRower, is a premium hardwood with incredible longevity and dimensional stability. In addition, the wood is harvested from replenishable forests and is hand finished with Danish oil and urethane for protection.
I kayak (ocean and flat water, not river), so I was drawn to the WaterRower over a flywheel type rower (which I have used in gyms) because I wanted to hear the sound of the water, which I miss hearing against the hull of the boat during the winter when I can't get out on the lake. I also like the way the paddles engage in the water; it's a very smooth pull and release, and moving the mass of the water instead of a dialed down tension feels more natural. As someone else also commented, the seat (at least on the wood version) is incredibly smooth and solid; no wobbling at all. I generally listen to music on my Nordic Track ski machine, but with the WaterRower I am content to listen to the sound of the water; working out on this is somehow both energizing and calmingly meditative at the same time. In the event that you want to use it while watching tv (this is one use to which I wanted to put it), it is quiet enough to hear the tv without having to turn it up.
×