Outside of resistance type, we found the number-one arbiter of ride feel to be cord quality. Water ergometers tend to employ nylon cords, while air ergometers feature metal chains — a durability factor we anticipated would result in our favoring air. But while all three water rowers aced our expectation of smooth, high-tension strokes, perfecting the chain seems to be more difficult: Some tug with just a slight rumble, others feature bouncy, grinding chains that are incredibly loud, something akin to angry snoring. As for nylon, the best wind and unwind like elastic silk — no slack, no sound, no catching, just perfectly even tension throughout the stroke.
After reading so many fantastic reviews I purchased the Classic model. Before I write what I think are the negative aspects I'll say that it gives a great workout! That is pretty obvious and I don't think that part is arguable. The disappointment began while unpacking. The wood parts were wrapped fairly well and did not have damage but there were several scratches that I had to sand out and re-oil. It appears that they were there before shipping. Putting it together would have been fast and easy- except 2 of the bolts were bent at about 15 degrees and would not fit. I had to wrap with tape and bend with vice grips. After getting it all together the rower worked well for about a week. I started to notice an annoying kind of popping sound from the left rail as the wheels rolled over on each stroke and recovery. It seems the plastic that the wheels ride on is not flat or adhered well to the rail. It isn't very loud but I can hear it well and it gets my attention, spoiling the nice sound of the water. Really disturbing. Support at WaterRower would like a video of the issue. Seems like an obvious issue and could swap out with a rail that is good instead of me trying to make a video of this small sound while moving the seat back and forth. For a $1500 machine the quality control- or lack of it is disturbing. Having to jump through a bunch of hoops because they are too cheap to just send a part is even more so. Perhaps I am being difficult but it is upsetting to have something touted as so great but put together like a $200 piece of junk. Another complaint would be the lack of any back lighting on the monitor. Really cannot see it if the lights are low. Being able to remove the monitor to attach to a PC wouldn't hurt either. While it gives a good workout the rower really suffers from poor manufacturing.
After reading so many fantastic reviews I purchased the Classic model. Before I write what I think are the negative aspects I'll say that it gives a great workout! That is pretty obvious and I don't think that part is arguable. The disappointment began while unpacking. The wood parts were wrapped fairly well and did not have damage but there were several scratches that I had to sand out and re-oil. It appears that they were there before shipping. Putting it together would have been fast and easy- except 2 of the bolts were bent at about 15 degrees and would not fit. I had to wrap with tape and bend with vice grips. After getting it all together the rower worked well for about a week. I started to notice an annoying kind of popping sound from the left rail as the wheels rolled over on each stroke and recovery. It seems the plastic that the wheels ride on is not flat or adhered well to the rail. It isn't very loud but I can hear it well and it gets my attention, spoiling the nice sound of the water. Really disturbing. Support at WaterRower would like a video of the issue. Seems like an obvious issue and could swap out with a rail that is good instead of me trying to make a video of this small sound while moving the seat back and forth. For a $1500 machine the quality control- or lack of it is disturbing. Having to jump through a bunch of hoops because they are too cheap to just send a part is even more so. Perhaps I am being difficult but it is upsetting to have something touted as so great but put together like a $200 piece of junk. Another complaint would be the lack of any back lighting on the monitor. Really cannot see it if the lights are low. Being able to remove the monitor to attach to a PC wouldn't hurt either. While it gives a good workout the rower really suffers from poor manufacturing.
Reviews.com has an advertising relationship with some of the offers included on this page. However, the rankings and listings of our reviews, tools and all other content are based on objective analysis. For more information, please check out our full Advertiser Disclosure. Reviews.com strives to keep its information accurate and up to date. The information in our reviews could be different from what you find when visiting a financial institution, service provider or a specific product’s website. All products are presented without warranty.
Assembly was challenging. One of the rails could not be attached because the embedded screw in the cross-beam was too crooked to fit into the hole on the rail. I had to place a nut on it to protect the screws and tap until it was true enough cap nut to be attached. The foot board is slightly wider than the top board. I will sand this to match when I reapply the finish. This will need to be done because the wood has a dry, ashy appearance. The wood is beautiful and mostly uniform. This rowing machine is a nice product, but the build quality of the unit I received was disappointing. I felt lucky that the gashes in the carton did not damage the product as the packaging was optimistic. The leading competitor I use at the gym seems to provide slightly more resistance. It is beautiful and useful, but with room for improvement.
Performance is meaningless if you can’t or don’t want to use the equipment, and that’s why the Wave Water rower was built for comfort and convenience. With a wide, molded seat to accommodate users of all sizes and a padded, textured rowing handle, you can build your strength and endurance in ease. When setting up the rower, the leveling endcaps with a dial ensure stability. After your workout, storing your Wave Water rower is easy – just fold the frame and roll the rower into a closet or corner.
However, I own an air rower and have zero worries about maxing out it’s ability. I can completely exhaust myself on any type of workout. Air and water rowers are the chosen resistance type by Olympic athletes and any athlete looking to train their full-body cardio. I don’t think they would choose this resistance type if they felt they could max it out.
* While there is nothing to adjust from row to row on the WaterRower, it is possible to increase or decrease the level of resistance by changing how much water you put in the drum. The monitor is pre-calibrated to match 17 liters of water, but you can change that if you want. More than 17 liters = more resistance, up to the max fill line. This is not something you'll want to change frequently, it's more of a set-it-and-forget-it thing.
On theme with C2’s interchangeability, models D or E are essentially the same machine. When we talk about one we’re talking about both. The Concept 2 E is just 8 pounds heavier but is made out of stronger stuff all around — what’s plastic on the model D is aluminium on the model E, and what’s aluminum on the model D is welded steel on the model E. The only noticeable variations are seat height and display position.
The WaterRower Natural is handcrafted from solid Ash wood, finished with a honey oak stain and danish oil. The WaterRower's patented WaterFlywheel has been specifically designed to emulate the dynamics of a boat moving though water and is unsurpassed in its simulation of the physical and physiological benefits of rowing. WaterRower will not provide support or documentation for any product transported outside of the original country of purchase
×