From a fitness perspective, the WaterRower Classic works 84 percent of your muscle mass, helping tone and strengthen your muscles while burning far more calories than most other aerobic machines. The exercise is also low impact, as it removes all the body weight from the ankles, knees, and hips, but still moves the limbs and joints through a full range of motion--from completely extended to completely contracted.
This piece of finely tuned, hand-crafted, water-resistance workout equipment also sits at the top end of the rowing machine spectrum. Employing a water flywheel that helps to mimic the feel of rowing in actual water, the natural wood WaterRower Rowing Machine will bring you a smooth, yet challenging workout that is as tough as you want it to be. If rowing is one of the best exercises you can do for your body as far as natural motion with low to no-impact, then the WaterRower is one of the best machines to do it on.

Unlike the 1445, the Elite Wave Water Rowing Machine includes an upgraded, high-end fitness monitor and a chest strap heart rate sensor. Programmed to sync seamlessly with the multi-function monitor, the data the sensor provides allows you to tailor your workout. For example, you can target a certain heart rate for weight loss or to increase endurance by adjusting your rowing speed and therefore, your rowing intensity. In addition to pulse, the multi-function monitor also tracks distance, time, calories burned, stroke count and strokes per minute to further motivate you during your rowing session. For further customization, users can also add or remove water using the included siphon to either increase or decrease the resistance.
Assembly was challenging. One of the rails could not be attached because the embedded screw in the cross-beam was too crooked to fit into the hole on the rail. I had to place a nut on it to protect the screws and tap until it was true enough cap nut to be attached. The foot board is slightly wider than the top board. I will sand this to match when I reapply the finish. This will need to be done because the wood has a dry, ashy appearance. The wood is beautiful and mostly uniform. This rowing machine is a nice product, but the build quality of the unit I received was disappointing. I felt lucky that the gashes in the carton did not damage the product as the packaging was optimistic. The leading competitor I use at the gym seems to provide slightly more resistance. It is beautiful and useful, but with room for improvement.
Of the four types of rowing machines or ergometers, water rowers are best at reproducing the sensation of on-water rowing. Their stroke cycles hold true to the dynamics of real paddling, and each stroke is punctuated with a splash! Water rowers have sliding seats to allow full-body cardiovascular workouts. (With cheaper rowing machines, in contrast, the seats don’t move.) These fitness machines tend to feature high quality parts and can last a lifetime.
After reading so many fantastic reviews I purchased the Classic model. Before I write what I think are the negative aspects I'll say that it gives a great workout! That is pretty obvious and I don't think that part is arguable. The disappointment began while unpacking. The wood parts were wrapped fairly well and did not have damage but there were several scratches that I had to sand out and re-oil. It appears that they were there before shipping. Putting it together would have been fast and easy- except 2 of the bolts were bent at about 15 degrees and would not fit. I had to wrap with tape and bend with vice grips. After getting it all together the rower worked well for about a week. I started to notice an annoying kind of popping sound from the left rail as the wheels rolled over on each stroke and recovery. It seems the plastic that the wheels ride on is not flat or adhered well to the rail. It isn't very loud but I can hear it well and it gets my attention, spoiling the nice sound of the water. Really disturbing. Support at WaterRower would like a video of the issue. Seems like an obvious issue and could swap out with a rail that is good instead of me trying to make a video of this small sound while moving the seat back and forth. For a $1500 machine the quality control- or lack of it is disturbing. Having to jump through a bunch of hoops because they are too cheap to just send a part is even more so. Perhaps I am being difficult but it is upsetting to have something touted as so great but put together like a $200 piece of junk. Another complaint would be the lack of any back lighting on the monitor. Really cannot see it if the lights are low. Being able to remove the monitor to attach to a PC wouldn't hurt either. While it gives a good workout the rower really suffers from poor manufacturing.
The WaterRower Classic is handcrafted from solid American Black Walnut wood, finished with danish oil. The WaterRower's patented WaterFlywheel has been specifically designed to emulate the dynamics of a boat moving though water and is unsurpassed in its simulation of the physical and physiological benefits of rowing. WaterRower will not provide support or documentation for any product transported outside of the original country of purchase
Proposition 65 requires businesses to provide Californians with a clear and reasonable warning about chemicals in the products they purchase, in their home or workplace, or that are released into the environment. By providing this information, Proposition 65 enables Californians to make informed decisions about protecting themselves from exposure to these chemicals. Proposition 65 also prohibits California businesses from knowingly discharging significant amounts of listed chemicals into sources of drinking water.

Because of the vast array of products that might contain one of the chemicals or ingredients on the list, we must include Proposition 65 warnings in our communications with you. We are required to use exact wording as specified by the state of California. While the warning sounds alarming, the purpose is to notify you of the potential risk so that you can make an informed buying decision.

The Water Rower comes partly preassembled in two large boxes. The assembly instructions are reasonably good, and as long as you take your time and follow them carefully (read all the text) it takes about 45 minutes from opening the first box to trying it out. I bought bottles of distilled water to fill it, which made it easy to fill using the included funnel & hose.
×