After reading so many fantastic reviews I purchased the Classic model. Before I write what I think are the negative aspects I'll say that it gives a great workout! That is pretty obvious and I don't think that part is arguable. The disappointment began while unpacking. The wood parts were wrapped fairly well and did not have damage but there were several scratches that I had to sand out and re-oil. It appears that they were there before shipping. Putting it together would have been fast and easy- except 2 of the bolts were bent at about 15 degrees and would not fit. I had to wrap with tape and bend with vice grips. After getting it all together the rower worked well for about a week. I started to notice an annoying kind of popping sound from the left rail as the wheels rolled over on each stroke and recovery. It seems the plastic that the wheels ride on is not flat or adhered well to the rail. It isn't very loud but I can hear it well and it gets my attention, spoiling the nice sound of the water. Really disturbing. Support at WaterRower would like a video of the issue. Seems like an obvious issue and could swap out with a rail that is good instead of me trying to make a video of this small sound while moving the seat back and forth. For a $1500 machine the quality control- or lack of it is disturbing. Having to jump through a bunch of hoops because they are too cheap to just send a part is even more so. Perhaps I am being difficult but it is upsetting to have something touted as so great but put together like a $200 piece of junk. Another complaint would be the lack of any back lighting on the monitor. Really cannot see it if the lights are low. Being able to remove the monitor to attach to a PC wouldn't hurt either. While it gives a good workout the rower really suffers from poor manufacturing.
Here’s a secret, because the rowing machine provides an intense full body workout, the exercise burns a high amount of calories not only during the actual activity but also for a period after you’ve stopped. This is known as the “after-burn effect”. Essentially, you’ve worked your body so hard that it is forced to keep burning calories and fat even when you’re not rowing. The scientific jargon for this is “excess post-exercise oxygen consumption” or “EPOC” for short. But all you need to know is that if you’re doing an intense rowing workout, the benefits continue after you’re done. How great is that?
However, I own an air rower and have zero worries about maxing out it’s ability. I can completely exhaust myself on any type of workout. Air and water rowers are the chosen resistance type by Olympic athletes and any athlete looking to train their full-body cardio. I don’t think they would choose this resistance type if they felt they could max it out.
If you’re interested in using a rowing machine for focused training — whether for outdoor rowing, an indoor competition, or as part of a larger fitness program — you’ll want air resistance. If you’re drawn to rowers for the enjoyability (alongside the full-body, cardio-plus-strength training efficacy) of a rowing workout, consider a machine with water resistance.
The Classic Rowing Machine is designed is extremely easy to use. Additionally, it has a lot of comfort features in its design. It has an ergonomically shaped handle and padded heel rests that accommodate nearly everyone. Everything on the machine can be adjusted quickly. Because there are no movement parts, maintenance is minimal. Even the computer has a lot of one button operations, so the minute you have the rower assembled, you can get to work.
Row, Jimmy, row…🎶 What’s one of the best things about using the WaterRower? There’s no such thing as an age limit when it comes to using it because of its ability to provide a workout with minimal impact on the joints. You don’t have to take our word for it, but we think you might want to take this fellas. Jimmy is 93 years young and hopped on the WaterRower for the first time yesterday. Let’s hear it for Jimmy!
Assembly was challenging. One of the rails could not be attached because the embedded screw in the cross-beam was too crooked to fit into the hole on the rail. I had to place a nut on it to protect the screws and tap until it was true enough cap nut to be attached. The foot board is slightly wider than the top board. I will sand this to match when I reapply the finish. This will need to be done because the wood has a dry, ashy appearance. The wood is beautiful and mostly uniform. This rowing machine is a nice product, but the build quality of the unit I received was disappointing. I felt lucky that the gashes in the carton did not damage the product as the packaging was optimistic. The leading competitor I use at the gym seems to provide slightly more resistance. It is beautiful and useful, but with room for improvement.
No matter the resistance we set or the power we applied, the machine remains sturdy, centered, and even. We amped up the intensity for 2000m sprints and found that the C2 supports consistent effort in a way water resistance can’t. The machine assists in keeping your intensity uniform, because it stores up remaining energy in the spinning flywheel. Comments about the ride feel of both Concept 2s were noticeably brief. As one tester put it, “It’s unremarkable because it’s good,” and leaves you free to focus on the effort you’re putting into your workout.
The Verified Sustainable Hardwoods used for the WaterRower are sourced from the Appalachian Mountain region of the eastern United States, where planting rates exceed harvest rates by an average multiple of 2.29. The Appalachian Hardwood Timber resource includes more than 65.4 million acres in the eastern United States and provides the world with a bounty of the finest hardwood species.
Although some rowing machines are made of space-age, super-sweat-resistant metals, you still want to wipe off the equipment after a sweaty workout. These machines are usually constructed with a lot of various materials and salty sweat can be very corrosive. Keeping your rowing machine clean can go a long way toward extending its life, and its appearance.
Being able to easily store your rower is a huge plus. Make sure you investigate how well the machine stores, if it folds up or comes apart easily to be able to put it in your closet, or in other storage areas. As an example, the Concept2 Model D rowing machine folds up nicely by a simple pull pin located in the middle of the rower. Wheels on the bottom allow for easy moving.
The WaterRower Club is outfitted with a Series 4 performance monitor that's designed to balance technical sophistication with user-friendliness. The monitor--which includes six information and programming windows, six QuickSelection buttons, and three navigation buttons--displays your workout intensity, stroke rate, heart rate, zone bar, duration, and distance. Plus, the monitor is compatible with an optional heart rate chest strap and receiver, which helps you optimize your workout and achieve your exercise objectives.
I kayak (ocean and flat water, not river), so I was drawn to the WaterRower over a flywheel type rower (which I have used in gyms) because I wanted to hear the sound of the water, which I miss hearing against the hull of the boat during the winter when I can't get out on the lake. I also like the way the paddles engage in the water; it's a very smooth pull and release, and moving the mass of the water instead of a dialed down tension feels more natural. As someone else also commented, the seat (at least on the wood version) is incredibly smooth and solid; no wobbling at all. I generally listen to music on my Nordic Track ski machine, but with the WaterRower I am content to listen to the sound of the water; working out on this is somehow both energizing and calmingly meditative at the same time. In the event that you want to use it while watching tv (this is one use to which I wanted to put it), it is quiet enough to hear the tv without having to turn it up.