After reading so many fantastic reviews I purchased the Classic model. Before I write what I think are the negative aspects I'll say that it gives a great workout! That is pretty obvious and I don't think that part is arguable. The disappointment began while unpacking. The wood parts were wrapped fairly well and did not have damage but there were several scratches that I had to sand out and re-oil. It appears that they were there before shipping. Putting it together would have been fast and easy- except 2 of the bolts were bent at about 15 degrees and would not fit. I had to wrap with tape and bend with vice grips. After getting it all together the rower worked well for about a week. I started to notice an annoying kind of popping sound from the left rail as the wheels rolled over on each stroke and recovery. It seems the plastic that the wheels ride on is not flat or adhered well to the rail. It isn't very loud but I can hear it well and it gets my attention, spoiling the nice sound of the water. Really disturbing. Support at WaterRower would like a video of the issue. Seems like an obvious issue and could swap out with a rail that is good instead of me trying to make a video of this small sound while moving the seat back and forth. For a $1500 machine the quality control- or lack of it is disturbing. Having to jump through a bunch of hoops because they are too cheap to just send a part is even more so. Perhaps I am being difficult but it is upsetting to have something touted as so great but put together like a $200 piece of junk. Another complaint would be the lack of any back lighting on the monitor. Really cannot see it if the lights are low. Being able to remove the monitor to attach to a PC wouldn't hurt either. While it gives a good workout the rower really suffers from poor manufacturing.

No matter the resistance we set or the power we applied, the machine remains sturdy, centered, and even. We amped up the intensity for 2000m sprints and found that the C2 supports consistent effort in a way water resistance can’t. The machine assists in keeping your intensity uniform, because it stores up remaining energy in the spinning flywheel. Comments about the ride feel of both Concept 2s were noticeably brief. As one tester put it, “It’s unremarkable because it’s good,” and leaves you free to focus on the effort you’re putting into your workout.

The WaterRower Oxbridge is hand crafted in solid Cherrywood. Like all woods, Cherrywood may vary in color from a red-brown to deep red. The wood will darken in color with exposure to light. For this reason all WaterRower Cherrywood components are kept in light free rooms to protect from shadowing. A new WaterRower Oxbridge will therefore appear quite light in color. The wood will however darken over time reaching a rich reddish hue. Each machine has been hand finished with three coats of Danish Oil giving a deep lustre an warmth to the wood. Wood has been chosen due to its marvellous engineering properties, primary amongst these is its ability to absorb sound and vibration enhancing the WaterRower's quietness and smoothness of use. Cherrywood, like all woods used in WaterRower construction, is a premium hardwood with incredible longevity and dimensional stability. For reasons of ecology, all our woods are harvested from replenishable forests.


Rowing is primarily a cardio workout, but it’s also more than that. Your heart rate is absolutely going to be climbing, but unlike a jog in the park, you might also be sore the next day. The rower requires you use your legs more than anything, and as we know, your quads, glutes, calves, and hamstrings are the biggest, most powerful muscles in your body. But you’re also pulling with your arms, shoulders, abs and engaging your back. That said, you’re not pulling as hard as you might with, say, a seated cable row machine at the gym. You don’t want to hurt your back, but you can engage them and this will help you get those muscles toned.
Products listed as Out of Stock are currently not in stock at the store(s) being viewed. Note that in some instances, very limited inventory may be available in stores, but because of small quantities we are unable to reflect the availability online. Please remember to check back – if or when inventory is replenished and available, this will be reflected online.
If you are anything like me, you read the negative reviews to see what some of the complaints could potentially be...I have found none that match with my machine or experience so far. The boxes it came in were a little bunged-up but everything on the inside was perfect. Only took about 15-20 minutes to build (first time building a row machine) and another 5-10 to fill with water. We used it for a little while before we added the danish oil.
The WaterRower Natural is hand crafted in solid Ash and stained Honey Oak for consistency of color. Each machine has been hand finished with Danish Oil giving a deep lustre an warmth to the wood. Wood has been chosen due to its marvellous engineering properties, primary amongst these is its ability to absorb sound and vibration enhancing the WaterRower's quietness and smoothness of use.
The advantages with air rowers is that there is smooth action; there is only small wear and tear to its mechanism; its automatic feature adjusts according to your rate of strokes; and there is a wide range of the resistance readily available in replicating the feel of rowing through the waters. The only disadvantage of this machine is that it tends to be noise indoors.
Storage is also a plus point for the Waterrower series as they are all designed to stand upright with the tank acting as ballast for stability. In this position they only take up around two square feet. Again, great if you are planning on training in the living room. However, if you have small children, I would advise fixing the top to the wall with a hook and strap.
Products listed as Out of Stock are currently not in stock at the store(s) being viewed. Note that in some instances, very limited inventory may be available in stores, but because of small quantities we are unable to reflect the availability online. Please remember to check back – if or when inventory is replenished and available, this will be reflected online.
The WaterRower Natural rowing machine is handcrafted in solid ash wood, stained Honey Oak, and finished with Danish oil. Wood is an excellent material for this application due to its ability to absorb sound and vibration enhancing the WaterRower's smooth, quiet operation. The Natural, as with all WaterRowers, features patented WaterFlywheel technology, unrivaled in its replication of the resistance felt in on the water rowing.
Unlike its WaterRower Natural cousin, the WaterRower Club is designed for high-traffic areas, such as commercial gyms, studios, and rehabilitation clinics. Its dual black rails have been styled to prevent scuffing, while the other wood components are finished in an attractive rosewood, which is more resistant to soiling than the Natural model. Other details include four corner wheels on the rails that increase seat stability and reduce the amount of sweat buildup; a frame that flips upright for handy storage; and a weight capacity of up to 1,000 pounds. The WaterRower Club measures 84 by 21 by 22 inches (W x H x D), weighs 117 pounds (with water), and carries a one-year warranty on the frame and components (WaterRower will upgrade the warranty to five years on the frame and three years on the components with the completion of a registration form).

However, I own an air rower and have zero worries about maxing out it’s ability. I can completely exhaust myself on any type of workout. Air and water rowers are the chosen resistance type by Olympic athletes and any athlete looking to train their full-body cardio. I don’t think they would choose this resistance type if they felt they could max it out.
The WaterRower Classic is handcrafted in solid American black walnut, which may vary in color from rich brown to purple/black. The black walnut was chosen due to its marvelous engineering properties, especially its ability to absorb sound and vibration, which enhances the WaterRower's quiet performance and smooth operation. Black walnut, like all woods used in the construction of the WaterRower, is a premium hardwood with incredible longevity and dimensional stability. In addition, the wood is harvested from replenishable forests and is hand finished with three coats of Danish oil to give it a deep luster and warmth.
The resistance of your rowing machine impacts how it moves. Select from hydraulic and magnetic rowing resistance. Hydraulic rowers are typically more compact in size, while magnetic machines make little noise as they operate. Details like easy-to-reach tension knobs or buttons allow you to increase or decrease the intensity of your resistance as you train.
The WaterRower Club is handcrafted in solid ash and stained for color. The wood was chosen due to its marvelous engineering properties, especially its ability to absorb sound and vibration, which enhances the WaterRower's quiet performance and smooth operation. Ash, like all woods used in the construction of the WaterRower, is a premium hardwood with incredible longevity and dimensional stability. In addition, the wood is harvested from replenishable forests and is hand finished with Danish oil and urethane for protection.
There is some minor maintenance. Because it's made out of wood, which can expand and contract, the bolts need tightening every few months or so. It's easy and takes only a couple of minutes. That, and putting in a fresh water purification tablet every six to twelve months, are about it for regular maintenance. The only problem I've had with the rower (the reason for 4 stars instead of 5) was a squeak that developed after about 6 weeks. It took me some time to determine the source of the squeak, which was a metal bracket connecting the footrest board to the horizontal boards above the drum. I had to partially disassemble the top section and tighten four bolts, but that fixed the problem and it's been quiet ever since.
×