The WaterRower Club is handcrafted in solid ash and stained for color. The wood was chosen due to its marvelous engineering properties, especially its ability to absorb sound and vibration, which enhances the WaterRower's quiet performance and smooth operation. Ash, like all woods used in the construction of the WaterRower, is a premium hardwood with incredible longevity and dimensional stability. In addition, the wood is harvested from replenishable forests and is hand finished with Danish oil and urethane for protection.
Award Winning Design - The WaterRower has been designed to set it apart from other fitness equipment, featuring an attention to detail unseen in other exercise equipment. Refined Design - The WaterRower has been designed to set it apart from other fitness equipment, featuring an attention to design refinement unseen in other exercise equipment. Hand Crafting - WaterRower’s wooden models are handcrafted from a selection of the world’s finest hard woods (Ash, Cherry, Walnut, Beech and Oak).. Each model is hand finished and coated with Danish oil giving it a deep penetrating Luster. Sustainable & Eco-Friendly - All WaterRower's wooden models are crafted from the finest Appalachian hardwoods sourced only from replenishable forests.
This elegant rowing machine builds strength and stamina by closely simulating a real world rowing experience. Its patented Waterflywheel, which moves through actual water, provides a smooth stroke that exercises 84% of your muscle mass evenly and prevents injuries. When not in use, the WaterRower can be stored vertically against a wall. Made in the USA from ethically sourced walnut wood. Assembly required.
After reading so many fantastic reviews I purchased the Classic model. Before I write what I think are the negative aspects I'll say that it gives a great workout! That is pretty obvious and I don't think that part is arguable. The disappointment began while unpacking. The wood parts were wrapped fairly well and did not have damage but there were several scratches that I had to sand out and re-oil. It appears that they were there before shipping. Putting it together would have been fast and easy- except 2 of the bolts were bent at about 15 degrees and would not fit. I had to wrap with tape and bend with vice grips. After getting it all together the rower worked well for about a week. I started to notice an annoying kind of popping sound from the left rail as the wheels rolled over on each stroke and recovery. It seems the plastic that the wheels ride on is not flat or adhered well to the rail. It isn't very loud but I can hear it well and it gets my attention, spoiling the nice sound of the water. Really disturbing. Support at WaterRower would like a video of the issue. Seems like an obvious issue and could swap out with a rail that is good instead of me trying to make a video of this small sound while moving the seat back and forth. For a $1500 machine the quality control- or lack of it is disturbing. Having to jump through a bunch of hoops because they are too cheap to just send a part is even more so. Perhaps I am being difficult but it is upsetting to have something touted as so great but put together like a $200 piece of junk. Another complaint would be the lack of any back lighting on the monitor. Really cannot see it if the lights are low. Being able to remove the monitor to attach to a PC wouldn't hurt either. While it gives a good workout the rower really suffers from poor manufacturing.
The WaterRower Natural is handcrafted from solid Ash wood, finished with a honey oak stain and danish oil. The WaterRower's patented WaterFlywheel has been specifically designed to emulate the dynamics of a boat moving though water and is unsurpassed in its simulation of the physical and physiological benefits of rowing. WaterRower will not provide support or documentation for any product transported outside of the original country of purchase