1.) I keep reading about cracks and leaks that develop in the water tank. WaterRower even offers a tank repair kit for this very issue. It seems to me that this is a design flaw that they refuse to address, instead offering a fix for when it eventually occurs. Have you seen these tanks to eventually leak? I’m surprised they haven’t tried a one-piece tank.
Award Winning Design - The WaterRower has been designed to set it apart from other fitness equipment, featuring an attention to detail unseen in other exercise equipment. Refined Design - The WaterRower has been designed to set it apart from other fitness equipment, featuring an attention to design refinement unseen in other exercise equipment. Hand Crafting - WaterRower’s wooden models are handcrafted from a selection of the world’s finest hard woods (Ash, Cherry, Walnut, Beech and Oak).. Each model is hand finished and coated with Danish oil giving it a deep penetrating Luster. Sustainable & Eco-Friendly - All WaterRower's wooden models are crafted from the finest Appalachian hardwoods sourced only from replenishable forests.
This twenty minutes duration technique is designed to max your muscles out every interval, and at the same time the recovery periods assist in increasing the efficiency with the fat burning routine. Once you have prepared your rowing machine, set its resistance to four. Perform sets of ten, fifteen and twenty power strokes by pulling to handle towards the torso of your body, like doing a rowing motion. Do this motion as fast as your body permits you to. Separate your power strokes at sixty seconds, putting in only fifty percent the effort you did before this. Repeat this cycle until you have fully rowed for a total of twenty minutes.

Assembly was challenging. One of the rails could not be attached because the embedded screw in the cross-beam was too crooked to fit into the hole on the rail. I had to place a nut on it to protect the screws and tap until it was true enough cap nut to be attached. The foot board is slightly wider than the top board. I will sand this to match when I reapply the finish. This will need to be done because the wood has a dry, ashy appearance. The wood is beautiful and mostly uniform. This rowing machine is a nice product, but the build quality of the unit I received was disappointing. I felt lucky that the gashes in the carton did not damage the product as the packaging was optimistic. The leading competitor I use at the gym seems to provide slightly more resistance. It is beautiful and useful, but with room for improvement.
 Bring the unparalleled full-body workout of on-the-water rowing home with the premium design and feel of the XTERRA Fitness ERG600W Water Rower. The full body rhythmic nature of rowing makes it wonderfully efficient at burning calories while also developing flexibility and strength. Plus, the "zen-like" water movement you hear from the ERG600W multi-bladed impeller can be soothing and meditative. The large and easy to read 5.5" LCD console with height and angle adjustment includes motivating programmable modes to keep you involved, inspired, and reaching your goals.

Performance is meaningless if you can’t or don’t want to use the equipment, and that’s why the Wave Water rower was built for comfort and convenience. With a wide, molded seat to accommodate users of all sizes and a padded, textured rowing handle, you can build your strength and endurance in ease. When setting up the rower, the leveling endcaps with a dial ensure stability. After your workout, storing your Wave Water rower is easy – just fold the frame and roll the rower into a closet or corner.
The WaterRower Classic Rowing Machine is a work of art. But before you buy one just to hang it on the wall, the more important feature of course is that this rowing machine is a high-quality, durable, and effective piece of exercise equipment that will help you get in top fitness with ease and low-impact comfort. With a user weight capacity of 1,000 lbs, WaterRower has built the Classic Rowing Machine to take everything you can throw at it. No matter how intense your workouts are, you’re not going to hurt this machine. And it accommodates everyone from beginner rowers to experienced die-hards.
Noise level is another large factor that tips the scale more towards water rowers. Air rowers make a fairly loud “whooshing” noise every stroke, which makes them bad for people who like watching TV, have sleeping children, live in apartments, or like working out early in the AM. Water rowers do make some noise but the splashing of water in the tank is a lot quieter and more soothing than the fan noise produced by air rowers.
Noise level is another large factor that tips the scale more towards water rowers. Air rowers make a fairly loud “whooshing” noise every stroke, which makes them bad for people who like watching TV, have sleeping children, live in apartments, or like working out early in the AM. Water rowers do make some noise but the splashing of water in the tank is a lot quieter and more soothing than the fan noise produced by air rowers.
There is much to love about the WaterRower--and I do love it--but I would echo others' comments that although the seat rolls solidly and smoothly on the wood rails, the seat itself is very hard (I use a gel seat pad I bought for my hard fiberglass kayak seat), and the footpads are in need up rethinking and upgrading--the cheap plastic doesn't let you row in socks or barefoot and is not really worthy of a machine that is otherwise a stunning piece of engineering and a beautiful one as well. As one other person noted about his machine, my machine made a clicking noise on the return stroke, so I had to adjust the wheel underneath the top rail that connects to the footpad and pull it away gently from where it was rubbing against another component. Also, be warned: the instruction booklet is in the DVD case. I did not see the little sticker on the case telling me that, thinking I'd wait to watch the DVD until after I'd assembled it. But WaterRower has a copy of the assembly instructions on their website, along with a video (I found the written ones better and easier to follow), so I was able to assemble it with no difficulty.
No matter the resistance we set or the power we applied, the machine remains sturdy, centered, and even. We amped up the intensity for 2000m sprints and found that the C2 supports consistent effort in a way water resistance can’t. The machine assists in keeping your intensity uniform, because it stores up remaining energy in the spinning flywheel. Comments about the ride feel of both Concept 2s were noticeably brief. As one tester put it, “It’s unremarkable because it’s good,” and leaves you free to focus on the effort you’re putting into your workout.
Assembly was challenging. One of the rails could not be attached because the embedded screw in the cross-beam was too crooked to fit into the hole on the rail. I had to place a nut on it to protect the screws and tap until it was true enough cap nut to be attached. The foot board is slightly wider than the top board. I will sand this to match when I reapply the finish. This will need to be done because the wood has a dry, ashy appearance. The wood is beautiful and mostly uniform. This rowing machine is a nice product, but the build quality of the unit I received was disappointing. I felt lucky that the gashes in the carton did not damage the product as the packaging was optimistic. The leading competitor I use at the gym seems to provide slightly more resistance. It is beautiful and useful, but with room for improvement.

The Concept2 Model D Indoor Rowing Machine includes the excellent PM5 monitor that provides all vital data. It can display your workout performance in two ways. You can choose to see your workout in total distance and time, or as “splits”. Splits is a way of seeing how your pace is varying along two set points. Either way is useful, but splits give you more of a “real-time”, in the moment calculation of how you are doing.
I teach pilates and also have several pieces of cardio equipment for my clients to warm up on. I bought a Hi, Rise Club Water Rower model a few years ago . as it turns out, my hard core bikers and elliptical walkers really did not use the Rower. SO it is in great shape. A beautiful piece.  I could not get a good photo in my house as there was not enough light, but if you Google this, you can see just what it looks like. 

There is some minor maintenance. Because it's made out of wood, which can expand and contract, the bolts need tightening every few months or so. It's easy and takes only a couple of minutes. That, and putting in a fresh water purification tablet every six to twelve months, are about it for regular maintenance. The only problem I've had with the rower (the reason for 4 stars instead of 5) was a squeak that developed after about 6 weeks. It took me some time to determine the source of the squeak, which was a metal bracket connecting the footrest board to the horizontal boards above the drum. I had to partially disassemble the top section and tighten four bolts, but that fixed the problem and it's been quiet ever since.
×