After reading so many fantastic reviews I purchased the Classic model. Before I write what I think are the negative aspects I'll say that it gives a great workout! That is pretty obvious and I don't think that part is arguable. The disappointment began while unpacking. The wood parts were wrapped fairly well and did not have damage but there were several scratches that I had to sand out and re-oil. It appears that they were there before shipping. Putting it together would have been fast and easy- except 2 of the bolts were bent at about 15 degrees and would not fit. I had to wrap with tape and bend with vice grips. After getting it all together the rower worked well for about a week. I started to notice an annoying kind of popping sound from the left rail as the wheels rolled over on each stroke and recovery. It seems the plastic that the wheels ride on is not flat or adhered well to the rail. It isn't very loud but I can hear it well and it gets my attention, spoiling the nice sound of the water. Really disturbing. Support at WaterRower would like a video of the issue. Seems like an obvious issue and could swap out with a rail that is good instead of me trying to make a video of this small sound while moving the seat back and forth. For a $1500 machine the quality control- or lack of it is disturbing. Having to jump through a bunch of hoops because they are too cheap to just send a part is even more so. Perhaps I am being difficult but it is upsetting to have something touted as so great but put together like a $200 piece of junk. Another complaint would be the lack of any back lighting on the monitor. Really cannot see it if the lights are low. Being able to remove the monitor to attach to a PC wouldn't hurt either. While it gives a good workout the rower really suffers from poor manufacturing.
From a fitness perspective, the WaterRower Club works 84 percent of your muscle mass, helping tone and strengthen your muscles while burning far more calories than most other aerobic machines. The exercise is also low impact, as it removes all the body weight from the ankles, knees, and hips, but still moves the limbs and joints through a full range of motion--from completely extended to completely contracted.
Of the four types of rowing machines or ergometers, water rowers are best at reproducing the sensation of on-water rowing. Their stroke cycles hold true to the dynamics of real paddling, and each stroke is punctuated with a splash! Water rowers have sliding seats to allow full-body cardiovascular workouts. (With cheaper rowing machines, in contrast, the seats don’t move.) These fitness machines tend to feature high quality parts and can last a lifetime.
Indoor rowing machines have come a long way and there are now a variety of sleek, highly-refined pieces of exercise equipment ready to get your cardio health on the upswing. Having a rower right there in your home can really be the push you need to get your muscles moving in a challenging yet comfortable way. Overall, rowing machines provide an outstanding way to increase fitness by burning calories and building muscle in a safe, low-impact way.
John Duke, creator of the WaterRower, was inspired to try his hand at invention while working at a subsidiary for U.S. Steel. He wanted to make an indoor machine that felt as much like real rowing as possible, with a focus on aesthetics. It took him two years to get the design right, moving past failed ideas such as a flipper in the tank instead of a clutch. What began as a series of doodles at his desk turned into a sculptural piece of exercise equipment that upends expectations in two ways: by bringing water indoors, and by looking elegant and artful when stored.

It's been nearly 30 years since John Duke, a former Yale University and USA National Team oarsman, set up a small shop in Rhode Island, USA to begin fine-tuning his innovative water-resistant rowing machine. With its beautiful design and unmatched feel, the WaterRower quickly gained a cult-like following of both on-water rowers and fitness enthusiasts that had found their perfect piece of workout equipment. As word spread of the new product that simulated the feel of on-water rowing, WaterRower transitioned from simply a one-off product found within the occasional boathouse to an established brand in both the rowing and fitness world.
As far as “racing”, I said an air rowing machine is better because the Concept2 is the only model used for indoor rowing competitions, setting world records, and entering your actual scores online. It is because their monitor can calculate the drag factor of the flywheel in real time and accurately calculate distance and time. Small changes such as dust build up, air temperature, and humidity will not change the times between different machines because the drag factor is calculated every stroke.
Chris Kinsey works as an editor for a medical publisher and has experience dealing with many topics, ranging from athlete's foot to cancer and brain injury. Kinsey has a great deal of freelance experience writing for sports and parenting magazines as well. Kinsey holds a Bachelor of Arts in communications from California University of Pennsylvania.

If the machine is to be housed on a wooden floor you will need a mat beneath to reduce vibration and also noise. If space is tight, the hydraulic options are usually the smallest. It's also worth checking your floor can take the weight if you're going for one of the bigger, heavier models. For most, this shouldn't be a problem, if you have any doubts get a surveyor to check as it could be a very expensive mistake!
The WaterRower Classic is handcrafted in solid American black walnut, which may vary in color from rich brown to purple/black. The black walnut was chosen due to its marvelous engineering properties, especially its ability to absorb sound and vibration, which enhances the WaterRower's quiet performance and smooth operation. Black walnut, like all woods used in the construction of the WaterRower, is a premium hardwood with incredible longevity and dimensional stability. In addition, the wood is harvested from replenishable forests and is hand finished with three coats of Danish oil to give it a deep luster and warmth.

* While there is nothing to adjust from row to row on the WaterRower, it is possible to increase or decrease the level of resistance by changing how much water you put in the drum. The monitor is pre-calibrated to match 17 liters of water, but you can change that if you want. More than 17 liters = more resistance, up to the max fill line. This is not something you'll want to change frequently, it's more of a set-it-and-forget-it thing.
×