A 125-pound person moving at an average pace for 30 minutes on a treadmill will burn roughly 250 calories. However, they aren’t able to take advantage of this after-burn effect. The same person rowing vigorously will burn around to 250 calories but will have less stress placed upon their joints and continue to burn calories after the workout has ended. Rowing machines have been shown to burn on average 800 calories an hour if you work harder and are slightly heavier.
If the machine is to be housed on a wooden floor you will need a mat beneath to reduce vibration and also noise. If space is tight, the hydraulic options are usually the smallest. It's also worth checking your floor can take the weight if you're going for one of the bigger, heavier models. For most, this shouldn't be a problem, if you have any doubts get a surveyor to check as it could be a very expensive mistake!

The WaterRower Club is hand crafted in solid Ash and stained for color. The WaterRower Club has been designed for High Traffic Areas such as Commercial Gyms, Studios, Rehabilitation Clinics, etc. Its Black Rails have been styled to prevent scuffing, other wooden components are finished in an attractive rosewood which are more resistant to soiling than the Natural model. Each machine has been hand finished with Danish Oil and Urethane for protection. Wood has been chosen due to its marvellous engineering properties, primary amongst these is its ability to absorb sound and vibration enhancing the WaterRower's quietness and smoothness of use. Ash, like all woods used in WaterRower construction, is a premium hardwood with incredible longevity and dimensional stability. s For reasons of ecology, all our woods are harvested from replenishable forests.


After reading so many fantastic reviews I purchased the Classic model. Before I write what I think are the negative aspects I'll say that it gives a great workout! That is pretty obvious and I don't think that part is arguable. The disappointment began while unpacking. The wood parts were wrapped fairly well and did not have damage but there were several scratches that I had to sand out and re-oil. It appears that they were there before shipping. Putting it together would have been fast and easy- except 2 of the bolts were bent at about 15 degrees and would not fit. I had to wrap with tape and bend with vice grips. After getting it all together the rower worked well for about a week. I started to notice an annoying kind of popping sound from the left rail as the wheels rolled over on each stroke and recovery. It seems the plastic that the wheels ride on is not flat or adhered well to the rail. It isn't very loud but I can hear it well and it gets my attention, spoiling the nice sound of the water. Really disturbing. Support at WaterRower would like a video of the issue. Seems like an obvious issue and could swap out with a rail that is good instead of me trying to make a video of this small sound while moving the seat back and forth. For a $1500 machine the quality control- or lack of it is disturbing. Having to jump through a bunch of hoops because they are too cheap to just send a part is even more so. Perhaps I am being difficult but it is upsetting to have something touted as so great but put together like a $200 piece of junk. Another complaint would be the lack of any back lighting on the monitor. Really cannot see it if the lights are low. Being able to remove the monitor to attach to a PC wouldn't hurt either. While it gives a good workout the rower really suffers from poor manufacturing.
I teach pilates and also have several pieces of cardio equipment for my clients to warm up on. I bought a Hi, Rise Club Water Rower model a few years ago . as it turns out, my hard core bikers and elliptical walkers really did not use the Rower. SO it is in great shape. A beautiful piece.  I could not get a good photo in my house as there was not enough light, but if you Google this, you can see just what it looks like. 
The WaterRower US office got in on the Pull for a Cure fundraising action and all pulled together to raise money for breast cancer! - - - - As many of you may already know, throughout the month of October, WaterRower has been raising money through our Pull for a Cure fundraiser. For each 500m workout rowed and posted online, we'll be donating $1 towards breast cancer research! Don't forget to get your workouts in before Monday, October 31st! #PullForaCure #WaterRower
The main advantages of the water rower are that it has quiet operation; there is only little maintenance to do, the water only needs to be changed occasionally; many users love the whooshing sound of water in the tank; and its consistently smooth resistance at every stroke. Two disadvantages of this machine are it costs a lot than the air rower; and it tends to be larger in size compared to the other rowing machines.
Fitness experts as well as health professionals agree that rowing machines provide one of the best workouts possible. Exercising on a rower will allow you to target the great majority of your muscle groups and give them as hard and challenging a workout as you feel like giving them. On the better rowing machine models, you’ll be able to track your progress and see how your splits are improving.

SquareTrade Protection Plans are only valid for new or Amazon certified refurbished products purchased at Amazon in the last 30 days. By purchasing this Protection Plan you agree to the Protection Plan Terms & Conditions (http://www.squaretrade.com/terms-standard). Your Protection Plan Terms & Conditions will be delivered via email within 24 hours of purchase

The Classic Rowing Machine is designed is extremely easy to use. Additionally, it has a lot of comfort features in its design. It has an ergonomically shaped handle and padded heel rests that accommodate nearly everyone. Everything on the machine can be adjusted quickly. Because there are no movement parts, maintenance is minimal. Even the computer has a lot of one button operations, so the minute you have the rower assembled, you can get to work.
If you are accustomed to the natural catch and feel of on-water rowing, your rowing technique will immediately appreciate the Apollo’s unrivalled emulation of a boat gliding through water. FDF’s patented twin tank design generates a smooth uniform stroke, including no lag of resistance at the catch and continued resistance all the way to the finish.
The WaterRower Club is handcrafted in solid ash and stained for color. The wood was chosen due to its marvelous engineering properties, especially its ability to absorb sound and vibration, which enhances the WaterRower's quiet performance and smooth operation. Ash, like all woods used in the construction of the WaterRower, is a premium hardwood with incredible longevity and dimensional stability. In addition, the wood is harvested from replenishable forests and is hand finished with Danish oil and urethane for protection.

The rowing machine itself is unlike any other on the market with its patented water filled flywheel. It is hard to exactly copy the action of a scull on the water, but the mechanics of the flywheel spinning in water comes in a close second on dry land. The fact that the water is 800 times denser than air means that there is no need for any extra resistance or dampening that you will find in normal air rowers. The faster you pull, the more resistance is generated giving it infinite variability. However, if you want to be able to practice rowing with a faster stroke, you will have to reduce the amount of water in the tank unlike an air rower where you just have to adjust the baffle.
Now back to the aesthetics, this version of WaterRower’s natural wood line of rowers comes in beautiful Black Walnut, which the company chose for its superior sound and vibration absorption. It’s hand-made in the USA and comes with excellent warranties and customer service. Overall, WaterRower is known for the quality of their rowing machines and the Classic is no exception.  And if you do want to get this rower just as an attractive conversation piece, it easily stores upright against a wall.  That said, we strongly recommend using The WaterRower Classic Rowing Machine for fitness, not just eye-candy.
Award Winning Design - The WaterRower has been designed to set it apart from other fitness equipment, featuring an attention to detail unseen in other exercise equipment. Refined Design - The WaterRower has been designed to set it apart from other fitness equipment, featuring an attention to design refinement unseen in other exercise equipment. Hand Crafting - WaterRower’s wooden models are handcrafted from a selection of the world’s finest hard woods (Ash, Cherry, Walnut, Beech and Oak).. Each model is hand finished and coated with Danish oil giving it a deep penetrating Luster. Sustainable & Eco-Friendly - All WaterRower's wooden models are crafted from the finest Appalachian hardwoods sourced only from replenishable forests.
Don't know why, perhaps due to rising demand and production bandwidth, but be forewarned quality control is an issue. Assembly is easy enough, though have gap where back separator does not fit snugly after tightening nuts as firm as they will go (see pic). No water level sticker on tank received, so had to measure water manually according to calculations (4 gallons). Siphon was not air tight (even though release valve closed firmly), so had to manually pump instead of siphon. S4 monitor only flashes, not working as of yet and now have to take a apart top of unit to figure out why, currently not resolved after verifying connections and looking at simple solutions on website.
1.) I keep reading about cracks and leaks that develop in the water tank. WaterRower even offers a tank repair kit for this very issue. It seems to me that this is a design flaw that they refuse to address, instead offering a fix for when it eventually occurs. Have you seen these tanks to eventually leak? I’m surprised they haven’t tried a one-piece tank.

On theme with C2’s interchangeability, models D or E are essentially the same machine. When we talk about one we’re talking about both. The Concept 2 E is just 8 pounds heavier but is made out of stronger stuff all around — what’s plastic on the model D is aluminium on the model E, and what’s aluminum on the model D is welded steel on the model E. The only noticeable variations are seat height and display position.


From a fitness perspective, the WaterRower Club works 84 percent of your muscle mass, helping tone and strengthen your muscles while burning far more calories than most other aerobic machines. The exercise is also low impact, as it removes all the body weight from the ankles, knees, and hips, but still moves the limbs and joints through a full range of motion--from completely extended to completely contracted.
The proper ratio of effort is about 75 percent lower body and 25 percent upper body. Ensure you’re hitting that by driving through your legs and keeping your hands relaxed. Posture plays a big part, too. Concept 2 recommends imagining your upright profile at noon and tilting from the 11 o’clock position (drive) to the 1 o’clock position (recovery).
The WaterRower Club is handcrafted in solid ash and stained for color. The wood was chosen due to its marvelous engineering properties, especially its ability to absorb sound and vibration, which enhances the WaterRower's quiet performance and smooth operation. Ash, like all woods used in the construction of the WaterRower, is a premium hardwood with incredible longevity and dimensional stability. In addition, the wood is harvested from replenishable forests and is hand finished with Danish oil and urethane for protection.

The WaterRower Natural rowing machine is handcrafted in solid ash wood, stained Honey Oak, and finished with Danish oil. Wood is an excellent material for this application due to its ability to absorb sound and vibration enhancing the WaterRower's smooth, quiet operation. The Natural, as with all WaterRowers, features patented WaterFlywheel technology, unrivaled in its replication of the resistance felt in on the water rowing.
The overall rowing experience encompasses pulley, seat, and — of course — resistance. Air and water have very distinct qualities, making them impossible to compare but interesting to contrast. Air stores inertia, which feeds into intense, constant effort during a goal-oriented workout. Water’s more sluggish drag makes for demanding exercise, but one that’s less consistent.
Performance is meaningless if you can’t or don’t want to use the equipment, and that’s why the Wave Water rower was built for comfort and convenience. With a wide, molded seat to accommodate users of all sizes and a padded, textured rowing handle, you can build your strength and endurance in ease. When setting up the rower, the leveling endcaps with a dial ensure stability. After your workout, storing your Wave Water rower is easy – just fold the frame and roll the rower into a closet or corner.

Another negative point for me is the angle of the seat. Unlike the Concept2, it has a slight backward angle, which makes it easier to maintain good form at the end of the stroke. Given that the Waterrower has greater resistance at the catch, it puts more pressure on the lower back at this point making it uncomfortable for people like myself with lumbar spine problems.

The water flywheel is comprised of two paddles encased in an enclosed tank of water. As you pull the cable, the paddles move through the water creating resistance. The beauty of this machine is it uses the mass/density of water. The paddles create the drag, so the harder you pull, the more resistance increases. Think about moving your hands through water. The faster you go, the more dense water feels. The slower you go, the less you feel the resistance. And this type of resistance is excellent for your joints. Click here to read the full review.


The WaterRower Natural rowing machine is handcrafted in solid ash wood, stained Honey Oak, and finished with Danish oil. Wood is an excellent material for this application due to its ability to absorb sound and vibration enhancing the WaterRower's smooth, quiet operation. The Natural, as with all WaterRowers, features patented WaterFlywheel technology, unrivaled in its replication of the resistance felt in on the water rowing.
From a fitness perspective, the WaterRower Club works 84 percent of your muscle mass, helping tone and strengthen your muscles while burning far more calories than most other aerobic machines. The exercise is also low impact, as it removes all the body weight from the ankles, knees, and hips, but still moves the limbs and joints through a full range of motion--from completely extended to completely contracted.

The dense resistance of water creates substantial drag, but on the WaterRower models, this is perfectly tempered by a whippy cord. It coils and recoils with such steady speed that one tester noted how the Classic “eats the rope back up on recovery.” This smooth agility helps balance out the impact of encountering slow water at the start of every stroke.
The overall rowing experience encompasses pulley, seat, and — of course — resistance. Air and water have very distinct qualities, making them impossible to compare but interesting to contrast. Air stores inertia, which feeds into intense, constant effort during a goal-oriented workout. Water’s more sluggish drag makes for demanding exercise, but one that’s less consistent.
Indoor rowing machines have come a long way and there are now a variety of sleek, highly-refined pieces of exercise equipment ready to get your cardio health on the upswing. Having a rower right there in your home can really be the push you need to get your muscles moving in a challenging yet comfortable way. Overall, rowing machines provide an outstanding way to increase fitness by burning calories and building muscle in a safe, low-impact way.

On theme with C2’s interchangeability, models D or E are essentially the same machine. When we talk about one we’re talking about both. The Concept 2 E is just 8 pounds heavier but is made out of stronger stuff all around — what’s plastic on the model D is aluminium on the model E, and what’s aluminum on the model D is welded steel on the model E. The only noticeable variations are seat height and display position.
The dense resistance of water creates substantial drag, but on the WaterRower models, this is perfectly tempered by a whippy cord. It coils and recoils with such steady speed that one tester noted how the Classic “eats the rope back up on recovery.” This smooth agility helps balance out the impact of encountering slow water at the start of every stroke.
The frame is beyond durable and is designed for absorbing sound and vibration. There’s no creaking or other sounds that you might expect from wood components. It has a low center of gravity that keeps the rower in place while exerting full rowing power. The polycarbonate water tank is equally durable and practically indestructible. The Classic Rower doesn’t have any moving parts that can wear out, or belts and pulleys that need to be maintained.
×